W1: Refers to the diameter of the tool holder, commonly used tool holder diameters include É 3.175, É 4, É 6, pieces
Set as needed.
W2: Refers to the width of the cutting edge, which directly affects the carving effect. When setting, it should be as accurate as possible, and a high-precision ruler can be used as a rough reference.
A: Half of the angle between the two edges of the blade tip. If it is a 30 ° tool, A is set to 15, and so on.
Carvable material: dual color board, PVC board, organic glass, ABS board, etc.
Cutting material: dual color board, ABS board.
Principle of using a knife: When carving small characters, use a W2 or A small dot knife, and when carving large characters, try to use a large knife to improve processing speed; The selection of cutting tools shall be based on the narrowest stroke; If necessary, node editing can be used to modify the stroke to facilitate the path of the large knife without affecting the font effect; Commonly used 30 ° cutting tools for carving chest badges; If the word is too small, you can replace it with a single line and use "cut" to calculate the path.