1, Acrylic cutting, it is recommended to use single-edged screw cutter, characterized by smokeless and tasteless processing speed, high efficiency, non-stick crumbs, real environmental protection, and its special manufacturing process to ensure the processing of acrylic does not pop , Fine knife pattern (or no knife pattern), the surface smooth and smooth. Surface to achieve the scrub effect, it is recommended to use double-edged three-edged spiral cutter.

2, MDF cutting, it is recommended to use double-edged chip-chip spiral cutter, it has two high-capacity chip flute, double-edged design, both with good chip evacuation function, but also to achieve a good tool balance, In the processing of high-density board, no black, no hat smoke, long service life and so on.

  

3, aluminum cutting, it is recommended to use single-blade aluminum cutter. Processing does not stick knife, fast, high efficiency.

  

4, precision small embossed processing, it is recommended to use a round bottom knife.

5, cork, MDF, virgin wood, PVC, acrylic large deep relief processing, it is recommended to use single-edged screw ball cutter.

  

6, the following burrless cutting process, it is recommended to use single-edged, double-edged cutting cutter.

  

7, high-density board, solid wood recommended edge cutter.

  

8, multilayer, plywood processing, it is recommended to use double-edged straight slot cutter.

  

9, under the effect of the use of cutters, no burr on the surface of the processed products, processing will not rocker.

  

10, acrylic mirror engraving recommended diamond engraving knife.

  

11, rough chipboard, etc. Recommended multi-fringe cutter.