Shank

In order to achieve the best results, as to make horn ds milling process to obtain satisfactory results, must choose the right tool holders. Each 1mm radial runout will reduce cutter durability, and will weaken its performance.

Universal shank or chuck slotted spring, due to its large runout does not apply to hard milling, hydraulic expansion or contraction of the liner pad to get the best results. This is the tool and die cutter system to be used horn, and horn din 6535 ha in accordance with standard tools, without exception, a straight cylindrical structure type design reasons. Additional clamping surface will destroy the accuracy of the tool, and affect its performance.

Cutting

Typically, the use hsc machining is possible for more than 56hrc workpiece hardness cutting. In this regard, with the proviso that the combined effect of the cutting speed and temperature. For hsc, the melting point of the workpiece material must be tested at an appropriate cutting speed. Usually higher than the melting point of the coating of the highest permissible temperature of the workpiece material, so be cautious. The best in this aphorism is "Keep tool cooling."